| Quantity(Ton) | 1 - 1000 | >1000 |
| Est. Time(days) | 2 | To be negotiated |
Kyrghyzstan kitchen tile glue
Introduction:
Tile Adhesive is a specially formulated cement-based adhesive for fixing ceramic floor and wall tiles on internal and external floors and walls.
It is used to fix porcelain tiles, marbles, natural granites, natural stones, travertine,pool tiles and pieces, and non-slip tiles of middle sized (up to 60x60cm size for the wall and any size for the floor).
Feature:
1. Has strong cohesion force. Reduce the common phenomenon of tiles detaching and peeling when pasted by Portland cement.
2. Be premixed and produced, the product is stable, water and used, to protect the construction environment.
3. Has strong water retention, no need to dip tiles and wet walls, thin construction, easy operation, to reduce material consumption and building load.
4. Has good flexibility to resist effectively the destruction of various stresses.
5. Has special formula to avoid completely the common phenomenon of tiles cracking, detaching and peeling by Portland cement.
6. It is no-toxic, no-radiation, no smell and environmental.
7. Has special formula to prevent the flow with too much southbound crash, easier construction.
Application:
1) Suitable for interior and exterior use.
2) Suitable for substrate made from concrete, masonry, pre-cast material and lightweight brick.
3) Suitable for walls,floors and roofs of architects, such as tunnels, bridges, basement, kitchen, bathroom, balcony, swimming pool and reservoir and so on.
4) Suitable for architects with structure which might easily vibrate and split, such as post-cast strip, pipe orifice.
Technical Date:
| FORM | Powder |
| COLOUR(S) | Grey or White |
| HAZARD INFORMATION | IRRITANT Consult Safety Datasheet before use |
| POTLIFE | Approx. 60 minutes @ 20°C |
| OPEN TIME | 20 minutes@ 20°C |
| COVERAGE | 5~8m2/25kg bag @3mm bed |
| TENSILE ADHESION STRENGTH | ≥1MPa under all test conditions |
| OPEN TIME | Approximately 10 minutes |
| EARLY TENSILE ADHESION STRENGTH | ≥ 0.8MPa after 6 hours |
Step Methods:
A:Primary treatment
Primary surface should be smooth solid, and fully dry, no sand, crack, bump inequality defects; no dust traces of oil and dirt. So, when the surface is rough or raised, application of trowels to its eradication, in order to deal with smooth surface.
B:Open the packing bags :
Cleaning benefits to cut off the dust, keep clean, open the package, with electric blender into uniform, no powder paste, mortar to be standing ten minutes after stirring once again increases the strength. The note, with the shovel to leave no droplet pulp scraping ideal condition.
C:Large area construction:
With a brush dipped in water, swipe the back of the tile, then wipe with a toothed blade to about one cubic meter of powder, then rub the pressure on the tile can be.
Application Picture:
Business Card:
